"CRUSHER" Camaro's EFI and Electronics |
Page 2 |
The firewall makes a good place to mount the MSD 6 AL Ignition Box and Blaster SS Coil |
High quality 1/0 Cable was used from the Optima Battery all the way up to front of the car. These connectors are the two piece compreesion type that screw together. A high quality adhesive type heat shrink tubing is used to insulate part of the connector |
A good ground is important on any vehicle. EFI places even more demand on the ground wire. The hex head of a 3/8-unc bolt was welded to the frame at the crossmember to insure the best possible contact. A drill and tap operation on the block end was performed on the Trick Flow aluminum block at the side of the dummy fuel pump boss. |
